If you know the offsets - you can also just enter the Station, Offset values into Excel and use the Station, Offset, Elevation importer to bring the points into the project. 100'ĥ) Explode the Corridor Surface Model that was created from the Instruction(s) above - you will have Linestrings that have nodes every 100' but also wherever the original Line had nodes also - so maybe not exactly what you want.Īlternatively you can as the others stated above use Linestring and switch from Coordinate Mode to Station and Offset Mode and then you can pick your HAL and create Points (using a linestring to do so) by entering your required Station values and for offset use the Perpendicular snap to find the point on your original line to derive the correct offsets. If you have the alignment and the Linestring(s) you could do any of the followingġ) Create a Corridor and reference the Linestring if 3D Line alreadyģ) In the Template create an instruction that uses Offset (2D Line if a Polyline) or that connects HAL to EOP if a 3D Linestring Referenced to the corridorĤ) Look at the properties f the Template and change the Template Interval from Project Setting to This template and then set the interval to what you want e.g.
0 kommentar(er)
